From Purchasing To Fitting: Steps For Rain Gutter Guard Installation In Melbourne
When it rains in Melbourne, it pours. Whenever rainwater gets to the foundation of your building, the integrity of the house is compromised. You need gutter to redirect the rainwater. Generally, rain gutters help to avoid soil erosion and basement leakages. Nevertheless, it’s crucial that the gutters are measured according to the size of your roof and fitted correctly. Gutter guard installations Melbourne involves the following simple steps:
1. Calculate the size and number of gutters needed
Essentially, the rain gutters should cover the perimeter of your roof. They are attached firmly to the fascia so as to collect the rainwater efficiently. You should purchase enough gutters to cover the entire house.
2. Use a chalk line to make layouts for the gutters
To do this, you are required to make the markings from the highest points to the lowest. The fascia points should be marked 3.2cm beneath the roof’s flashing.
3. Cut the rain gutters into precise sizes
You can use a robust tin snip or hacksaw to cut the gutters based on your calculated measurements. This is to ensure that you have enough gutters for the entire roof.
4. Fix the gutter brackets
The brackets can either be mounted on the face board or snapped onto the rain gutters. It all depends on the type of rain gutters you buy.
5. Make the downspout openings
You can cut the openings on the rain gutters using a jigsaw. The marking should be done precisely. To this easily, turn the gutter upside down then place the outlet top. Trace or mark the downspout hole in the gutter then drill about a quarter-inch diameter hole through the centre of the outline/mark.
6. Fix the downspout connectors to the gutters
You should use metal screws and silicone adhesives to attach the connectors to the gutters. For the open end runs of the gutters, you should use end caps.
7. Attach the gutters
This step marks the highlight of gutter installation in Melbourne. You are required to mount the brackets to the face board. You should use stainless steel screws to do it.
8. Fix the downspouts and seal the connections
The downspouts should be attached to the connectors in the right direction. Finally, the connections are sealed before they are allowed to dry overnight.
Conclusion
The above 8 steps are all you need to successfully buy and install rain gutters. If you are not a DIY guy, you can seek the service of an expert to help you do the installation so as to have perfectly-fitted gutters.