Lighting Audit In Texas

When it comes to lighting audit in Texas, clearly label all circuit breakers and fuse boxes. For each switch, be sure to indicate the outlet or device to which it corresponds. Avoid using outlets and power cords that have exposed wires. Do not use portable power tools that need to be connected without their protective devices. Clear access to circuit breakers, circuit breaker panels or fuse boxes.

In the event of an accident of an electrical nature, avoid touching the victim or the electrical device in question. Cut off the power first. What tips can be followed when using power tools?

Turn off all tools before connecting them to a power source. Cut and lock the power source before completing any maintenance work or making any adjustments. Make sure the tools are well grounded or double insulated. Never remove the third pin (ground) from a plug. The grounded tool must have a three-wire cord and a three-pin plug. The plug must be plugged into a properly grounded three-hole receptacle.

Check the grounding of all power tools with an ohmmeter or ground fault circuit interrupter (GFCI) before use. Avoid connecting and disconnecting the tool rather than using the switch to stop the tool and restart it. Do not operate power tools in wet or damp conditions unless the tools are equipped with a GFCI (ground fault circuit interrupter).

Do not use toxic or flammable solvents to clean power tools. Do not operate power tools in an area where vapors or explosive gases are present, unless they are intrinsically safe tools and only if you follow the manufacturer’s instructions.

What are some of the safety precautions for working with power cords? Spread the power cord of the tool you are using. Suspend power cords temporarily over walkways or work areas when working to avoid the risk of falling or tripping. Replace open-face plugs with insulated-face plugs. These are sealed and they present less risk of electric shock or short circuit.

Do not use extension cords for light work when work is not done in a residential setting. Do not lift or carry power tools while holding them by the power cord. Do not tie knots in the power cords. Nodes can cause shorts and shocks. Arrange the cords loosely or use a lockable jack.

Inspect extension cords and plugs daily. Do not use them and discard them if they are damaged. Have an electrician check any extension cord that feels warmer than normal. Avoid connecting multiple devices in one socket. To unplug a cord, pull the plug rather than the cord itself. Avoid turning off power to a device by pulling the cord out of the socket. This may damage the cord and cause shocks.