3 Key Points of Diamond Drilling Kalgoorlie

Diamond drilling in Kalgoorlie is a process that has been used for decades to create diamond holes. If you are looking to diamond drill Kalgoorlie, there are three important points you should know about diamond drilling before making your decision. 1) What size diamond will be required?, 2) How deep does the hole need to be drilled?, and 3) Where do I start and end the diamond hole?.

What size diamond will be required?

This diamond drilling question is one of the most important points to consider when looking at diamond drilling in Kalgoorlie. We recommend you choose a diamond that can drill into hard rocks, like quartzite or granite, and has an average life span (roughly 30 days). Drillers will try not to use diamonds with too many natural defects in them because it could cause premature wear on the diamond.

How deep does the hole need to be drilled?

Depth requirements for diamond holes vary depending upon your specific project needs. The deeper diamond holes typically mean larger diamonds are used which last longer but cost more money. For non-destructive testing, our staff would recommend no less than 100mm in depth while destructive tests may require up to 250mm+ diamond penetration.

Where do I start and end the diamond hole?

Diamond holes are usually started at the tip of a drill rod and finished on the side. If diamond drilling is performed for non-destructive testing, it would be ideal to start your diamond hole near the end that doesn’t necessarily have any special equipment attached (i.e., cones or cutters).

Why does my diamond hole look like it’s cracked?

Cracking in diamond-drilled rock occurs when there isn’t enough explosive energy transferred into the material you’re trying to drill through. This can happen for various reasons including low-quality explosives, poor placement by an operator with incorrect points of detonation, or the insufficient number of shots fired per blast event.

What is diamond drilling?

Diamond drill bits are used to make circular (or, occasionally diamond) shaped holes in the ground or any other material with a hardness of less than 12 Mohs scales. Diamond can be more efficient and faster than traditional drilling methods such as rotary, percussion, and auger because diamond tips provide higher compressive strength that allows for deep hole digging without an excessive amount of breaking.

Diamond also has excellent resistance to wear and thermal shock which means it can cut through tough materials like asphalt, concrete, and hard rocks while still lasting long enough to get the job done quickly.

How does it work?

Diamond core bit drills have three main components: a bit body containing bearing assemblies at each end; two diamond segments that are diamond-impregnated inserts affixed to the radial bearing assemblies; and a diamond cutting surface or drill point.

We hope this information on diamond drilling Kalgoorlie was helpful. Thank you for reading.